Rocker switch fits into .83 x 1.46 cutout.

Electrical 101:   Ok so you've seen some kits out there that have random parts thrown into a package by someone with zero electrical knowledge leaving it up to you to figure out how to make it all work.  This is NOT one of those!

This kit incorporates a pre-wired harness labeled and ready to install. Anyone with a little basic electrical common sense can install this kit in about an hour.

Again, no guessing as to what wire goes where or how to plug wires onto what terminal of the rocker switch.

It's all pre-wired!

It's as simple as this:

There are 2 SETS of marked wires on the harness: LEFT & RIGHT

These wire sets match the colors of the wires on the LED lights.

Run a wire to each corner of the vehicle where you'll butt it to the LED lights.

Connect the Left LED's to the harness marked LEFT

Connect the Right LED's to the harness marked RIGHT

There are 2 power wires to connect to the machine:    RED =12v+    BLACK= 12v-

That's it. DONE!